User's Guide

115
Configuring the IP address of the secondary NTP server
Overview
Configures the IP address of the secondary NTP server.
Command name
SET NETWORK NTP SECONDARY
Argument
<IP Address>
Execution example
Default value
“0.0.0.0”
Supplementary information
Configuring the name of a SNMP community allowing the Get operation
Overview
Configures the name of the SNMP community allowing the Get operation.
Command name
SET SNMP COMMUNITY READ
Argument
<Community name>
Use up to 32 characters to specify the SNMP community name.
When <Community name> is enclosed by double quotation marks (““) with nothing quoted
between the marks, the current community name will be cleared.
Example: „“SET SNMP COMMUNITY READ”‟
Execution example
Default value
“public”
Supplementary information
This command configures a community name for the Get operation.
If a different community name is specified by the command to configure the name of an SNMP
community allowing the Get/Set behaviors, which is described in the following section, note that
the Get operation works from both community names.