User's Guide

116
Configuring the name of a SNMP community allowing the Get/Set
operation
Overview
Configures the name of the SNMP community allowing the Get/Set operation.
Command name
SET SNMP COMMUNITY WRITE
Argument
<Community name>
Use up to 32 characters to specify the SNMP community name.
When <Community name> is enclosed by double quotation marks (““) with nothing quoted
between the marks, the current community name will be cleared.
Example: „“SET SNMP COMMUNITY WRITE”‟
Execution example
Default value
“public”
Supplementary information
This command configures a community name for the Get/Set operation.
If a different community name is specified by the command to configure the name of an SNMP
community allowing the Get/Set behaviors, which is described in the previous section, note that
the Get operation works from both community names.