User's Guide

157
Default value
Supplementary information
About Diagnostic Status
Internal Data Shows FRU information validity. OK: valid, Failed: invalid (checksum
error).
Management Processor Shows the status of BMCFW. OK: normal, Failed: failure
I/O Configuration Shows the E-Keying status. OK: E-Keying succeeded, Failed:
E-Keying failed
Power Shows the power status. OK: normal power status, Failed: power
problem
Cooling Shows the cooling status. OK: cooking OK, Failed: cooling problem
Not Performed: not checked
Location Shows the status of mounting location. OK: mounting location OK,
Failed: mounting location problem
Device Failure Shows failure status. OK: Normal operation, Failed. Failure, Not
Performed: not checked
Device Degraded Shows degraded status. OK: normal operation, Failed: degraded, Not
Performed: not checked
Configuring the power-on delay time of the CPU blade
Overview
This function is mainly useful for booting from SAN when the startup time of the FC disk is
shorter than that of CPU blades. If you enable AC-Link function of the CPU blade and set <Delay
time> longer than the setup time of the FC disk, the CPU blade is powered on after the FC disk
becomes ready.
Command name
SET SERVER POWERONDELAY
Argument
<Slot number> | <Slot number> - <Slot number> | <Slot number> , <Slot number> | “ALL”
Second Argument
<Delay time>
Configure in seconds
Range of configurable values: 0 to 65535 (“0”: disable)
Execution example
Example of execution of the command to configure the power-on delay time of the CPU blade