User's Guide

175
Configuring the DSG status
Overview
Configures an DianaScope Gateway (DSG) status.
Command name
SET DSGSTATE
Argument
“1” (Enable), “0” (Disable)
Execution example
Example of the DSG status configuration
Default value
“1” (Enable)
Supplementary information
When you do not want to disable the system monitoring by the DSG, you should run “SET
DSGSTATE 0”. This setting disables the system monitoring. In this setting, the EM firmware does
not make any responses to queries from the DSG.
When you want to enable the system monitoring by the DSG, you should run “SET DSGSTATE
1”. This setting enables the system monitoring. In this setting, the EM firmware will make
responses to queries from the DSG.
Displaying the DSG status
Overview
Displays an DianaScope Gateway (DSG) status.
Command name
SHOW DSGSTATE
Argument
Execution example
Example of the DSG status display
The output of this command includes:
1: Enable
2: Disable
Default value
Supplementary information