User's Guide

FCC Compliance

This product has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interface when the device is operated in a commercial environment. This device

generates uses and can radiate radio frequency energy and if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio communications. Operation of

this device in a residential area is likely to cause harmful interface in which case the use will be

required to correct the interference at one‟s own expense.

CE Statement

Warning: This is a Class A product. In domestic environment this product may cause radio interference in

which case the user may be required to take adequate measures (EN55022).

Trademarks

NEC EXPRESSBUILDER, NEC ESMPRO, NEC DianaScope, NEC EXPRESSSCOPE and NEC

SIGMABLADE are registered trademarks or trademarks of NEC Corporation.

Microsoft and Windows are trademarks of Microsoft Corporation in the United States and other countries.

About this Document

This document describes how to correctly connect the Enclosure Manager Card (EM Card) to a blade enclosure

(10U) “SIGMABLADE-Hv2” (N8405-040F) and how to use such system units.

Please refer to this document and the safety instructions in case of any uncertainty or if you have any problem

with HW/SW management/monitoring and remote management.

This document also describes the features of the SIGMABLADE Monitor and On Screen Display (OSD).

Keep this document near the device so that you can consult it if necessary.

Notes

(1) No part of this manual may be reproduced in any form without prior written permission of NEC

Corporation

(2) The contents of this manual are subject to change without prior notice.

(3) The contents of this manual shall not be copied or altered without prior written permission of NEC

Corporation

(4) All efforts have been made to ensure the accuracy of all information in this manual. If you find any part

unclear, incorrect, or omitted in this manual, contact the sales representative where you purchased this

product.

(5) NEC assumes no liability arising from the use of this product, nor any liability for incidental or

consequential damage arising from the use of this manual regardless of (4) above.