User's Guide

231
Apply
Click the [Apply] button at bottom of the screen to save the modified information in the configuration
file and apply it to EM card. When two EM cards are installed, the settings are applied to both cards.
When you click [Apply], the console checks the edited contents and, if there is no problem, applies the
configuration.
TIPS:
If any problem is detected, an error message is displayed and all items with problems are indicated in
red.
IMPORTANT:
After applying modifications to the power redundancy mode or the power control policy, be sure to
turn the power of the enclosure off and then on again.
CHECK:
When two EM cards are installed, is the Standby EM also working properly?
If the Standby EM is still booting or has failed, you cannot apply any changes. Wait until the Standby
EM is ready. If the Standby EM has failed, remove it before applying changes.
To display the current configuration, click “Reset.”