User's Guide

250
System Setup
Setting for EM
Sets an IP address of EM card itself, or a password for SIGMABLADE monitor.
When you select [5: SYSTEM CONFIG] on Main Menu, the submenu as shown below appears.
Press [↓] or [↑] button to increase or decrease the number at the cursor position in the range
between 0 and 9.
Press [→] or [←] button to move cursor horizontally.
Enter the four-digit character, then press the [Enter] button to determine it.
If the entered password agrees with the registered one, the [EM CONFIG] menu appears.
If the password does not agree, the below screen is displayed.
Press any button to return to the IP address configuration screen.
IMPORTANT:
The default password is “0000”. Change password according to description later.
[EM CONFIG] menu
PASSWD Not Match