User's Guide

262
EM Switchover
The following confirmation screen is displayed when you select [4: Switchover] on the [EM
Firmware Sub] menu.
Press [→] or [←] button to move cursor horizontally to switch selection between “Y” and “N”.
To cancel switchover, put the cursor on “N” and press the [Enter] button. The screen goes back to
[EM Firmware Sub] menu without changing the setting.
To execute switchover, put the cursor on “Y” and press the [Enter] button.
Upon completion of switchover, the LCD displays the results.
 When switchover completed successfully:
 When switchover failed:
 When standby EM does not work normally:
TIPS:
If you press any button while the results or the error message is being displayed, the screen goes back
to [EM Firmware Sub] menu.