Manualshelf

User's Guide

ManualsBrandsNEC ManualsBlade ServersNEC N8405-043 SIGMABLADE-Hv2 EM CARD
21222324252627282930
28
Chapter 2
Installation/Removal of EM Card
Two EM cards can be installed in the slots located at the front of the Blade Enclosure.
This section describes how to install the EM card in Blade Enclosure, and notes on using the EM card.
IMPORTANT:
The EM card may be installed or removed by any user. NEC assumes, however, no liability for
damage to devices or the server or malfunction of the server resulted from installation by the
user. NEC recommends you ask your service representative for installing or removing the EM
card.
Make sure to use only cables authorized by NEC. Repair of the server due to malfunctions,
failures, or damage resulted from using an unauthorized cables will be charged.