User's Guide

36
Initial Settings
Configure initial settings of modules installed on the blade enclosure such as EM cards and CPU blades
by using the EM serial console or the EM console.
CHECK:
 The default password for “Administrator” is “Admin”. For security change the default password
to new one.
 Configure the initial settings by “Administrator” or a user whose access right is
“ADMINISTRATOR” or “OPERATER.” Some initial settings accept only Administrator or a
user whose access right is “Administrator.”
 Configure the initial settings from the active EM card.
 The default value of IP address of EM card is 192.168.1.8 ~ 11 (subnet mask: 255.255.255.0).
When connecting to an EM card from the EM console for the first time after your purchase for
initial settings, connect to 192.168.1.8 (If the settings have not been changed).
Date and time settings (EM card)
1. Confirm whether the EM card is powered on.
2. Ensure that you have logged in as “Administrator” or a user whose access right is
“ADMINISTRATOR” or “OPERATOR” from a CLI of the EM serial console or the EM console.
(If you have not, log in as “Administrator” or a user whose access right is “ADMINISTRATOR”
or “OPERATOR.”)
3. Ensure that the following information by running commands on the CLI. (For details, refer
to ”Commands.”)
 Changing date settings (Required when not using the NTP function)
Configure date and time of an EM card.
SET DATE <MMDDhhmm({CC}YY)> <time zone>
- MM: month DD: date hh: time mm: minute CCYY: year
- time zone: refer to “Time zone” in “Appendix. (180 page) ” The default value is
JST.
 Configuring an NTP server
(For using the NTP function, you must configure the primary NTP server setting and
ENABLE NTP. Configuring the secondary NTP server is optional.)
Setup the NTP server to be referred by the EM card.
Before this, you must complete “Network settings (EM card)”.
(It takes about 5 seconds for the command to complete.)
SET NETWORK NTP PRIMARY <primary NTP server address>
(SET NETWORK NTP SECONDERY <secondary NTP server address>)
SET TIMEZONE <time zone>
 Time zone: refer to “Time zone” in “Appendixes. (180 page) ” The default value is
JST.
ENABLE NTP
4. Execute the command below on the CLI to check the settings you made have taken effect.
For details, refer to “.”
When the date and time settings have been modified, run the SHOW DATE command.
When the NTP server settings have been configured, run the SHOW NETWORK command.
This completes steps to configure date and time or NTP server settings.