User's Guide

37
User settings (EM card)
1. Confirm whether the EM card is powered on.
2. Confirm that you have logged in as “Administrator” or a user whose access right is
“ADMINISTRATOR” or “OPERATOR” from a CLI of the EM serial console or the EM console.
(If you have not, log in as “Administrator” or a user whose access right is “ADMINISTRATOR”
or “OPERATOR.”)
3. Configure the following information by running commands on the CLI. (For details, refer to
“Commands.”)
 Changing the password of Administrator (highly-recommended)
Change the password of Administrator.
The password can contain three to eight alphanumeric characters.
Do not forget the password of Administrator.
If you forget, password recovery is necessary. (For information on how to recover
password, refer to “Password recovery”.)
SET PASSWORD
New Password : ******** (Type a password)
Confirm : ******** (Type the same password)
 Registering regular users (when adding a user, ADD USER is required. FULL NAME
is optional.)
Register regular user accounts as necessary.
ADD USER <user name (within 13 characters)>
New Password : ******** (Type a password)
Confirm : ******** (Type the same password)
SET USER FULLNAME <user name> <full name (within 32 characters)>
 Configuring the access right of the regular users (optional)
Configure the access right of the regular users. (The default value of access right of regular
user is USER.)
SET USER ACCESS <user name> [ADMINISTRATOR | OPERATOR | USER]
TIPS:
When two EM cards are installed and you configure the password of the regular users or
Administrator
on the active EM card, the same values are automatically allocated to the standby EM card.
4. Execute the command below on the CLI to check the settings you made have taken effect
(for details, refer to “Commands”).
When you add users, or changed the access rights, run the SHOW USER <user name>
command.
This completes the steps to configure the user settings.