User's Guide

Rack settings (EM card)

1. Confirm whether the EM card is powered on.

2. Ensure that you have logged in as “Administrator” or a user whose access right is

“ADMINISTRATOR” or “OPERATOR” from a CLI of the EM serial console or the EM console.

(If you have not, log in as “Administrator” or a user whose access right is “ADMINISTRATOR”

or “OPERATOR.”)

3. Configure the following information about the rack by running commands on the CLI. (For details,

refer to “Commands.”)

 Rack name (required for report processing)

Configure the name of the rack on which the EM card is installed (within 32 characters).

(Specify any unique name to identify the rack.)

SET RACK NAME <rack name>

TIPS:

When interlude connection is enabled, the Rack Name is determined according to the Rack Name set

in the bottom blade enclosure unit. If you change the name when InterBlade connection is enabled,

the changed name will be reflected in all blade enclosures connected with this feature.

You can change a Rack Name from any one of the blade enclosures connected with InterBlade

connection.

4. Execute listed command in CLI mode. Confirm that the settings are applied. For detail, refer to

the command specification.

Execute "SHOW ENCLOSURE INFO" command when the name or asset number of enclosure is

defined.

This completes the steps to configure the user settings.