User's Guide

Blade Enclosure settings (EM card)

1. Confirm whether the EM card is powered on.

2. Ensure that you have logged in as “Administrator” or a user whose access right is

“ADMINISTRATOR” or “OPERATOR” from a CLI of the EM serial console or the EM console.

(If you have not, log in as “Administrator” or a user whose access right is “ADMINISTRATOR”

or “OPERATOR.”)

3. Configure the following information about the Blade Enclosure by running commands on the CLI.

(For details, refer to “Commands.”)

 Blade enclosure name (required for report processing)

Configure the name of the blade enclosure on which the EM card is installed (within 32

characters)

(Specify any unique name to identify the blade enclosure.)

SET ENCLOSURE NAME <the blade enclosure name>

 Blade Enclosure asset number (optional)

Configure an asset number of the blade enclosure on which the EM card is installed

(within 32 characters).

Configure any asset number of the blade enclosure (such as a number allocated for

managing assets in your organization).

SET ENCLOSURE ASSET TAG <the asset number>

4. Execute the command below on the CLI to check the settings you made have taken effect.

For details, refer to “Commands.”

When the name or asset number of the blade enclosure has been configured, execute the

SHOW ENCLOSURE INFO command.

This completes the steps to configure the user settings.