User's Guide

41
Configuration example
Note that the following is an example. Configure each IP address and subnet mask according to your
usage environment.
(1)
EM card –network configuration
Floating IP 192.168.1.4
Four consecutive IP addresses
(Specify the IP address of
floating IP (active EM))
(active EM)
Floating IP 192.168.1.5
(stand-by EM)
Static IP address 192.168.1.6
(EM card slot 1)
Static IP address 192.168.1.7
(EM card slot 2)
(2)
CPU blade (Slot 1~16) -network configuration
Slot 1 192.168.1.8
24 consecutive IP addresses
(Specify the IP address of CPU
blade (slot 1))
Slot 2 192.168.1.9
Slot 3 192.168.1.10
Slot16 192.168.1.23
(3)
Switch module (Slot1~8) -network configuration
Slot 1 192.168.1.24
Slot 2 192.168.1.25
Slot 3 192.168.1.26
Slot 8 192.168.1.31
(4)
Configuration of subnet mask and gateway (this configuration is used across EM cards, CPU
blades and switch modules)
Subnet mask 255.255.255.0
Gateway 192.168.1.99
(5)
Configuration of DNS server (this configuration is used across EM cards, CPU blades and
switch modules)
Primary DNS 192.168.1.111
Secondary DNS 192.168.1.123
4. Configure the following information by executing the commands on a CLI.
(For details, refer to “Commands.”).
CHECK:
If you change the IP address of the EM card while you are using a CLI on the EM console, the EM
console is disconnected from the EM card. Change the target IP address of the terminal emulator of
the EM console to the new IP address of the EM card to log on again. Depending on a new IP address
of EM card, values of the network configurations of EM console and other network machines must be
set to the appropriate values in advance.)
― Each IP address setting (Required)
Configure the network settings of EM cards, CPU blade and switch module.
(It takes about 5 seconds for the command to complete.)
SET NETWORK ADDRESSRANGE <the IP address of the floating IP
(active EM)> <the IP address of CPU blade (Slot1)> <subnet
mask>
Example SET NETWORK ADDRESSRANGE 192.168.1.4 192.168.1.8
255.255.255.0