User's Guide

DianaScope settings (EM card)

When using DianaScope Manager, you should create a user password of DianaScope Gateway on an

EM card. Follow the steps below to create a user account. DianaScope Manager requires authentication

key when you register a server. Configure the created user password as the authentication key.

Configure the static IP address of an EM card as the IP address of a server to be registered. (For the

static IP address of an EM card, refer to “Network settings (EM card).” For information on operation of

DianaScope, refer to the installation guide of DianaScope, or the user‟s guide or operation guide of the

CPU blade.)

1. Confirm whether the EM card is powered on.

2. Ensure that you have logged in as “Administrator” or a user whose access right is

“ADMINISTRATOR” or “OPERATOR” from a CLI of the EM serial console or the EM console.

(If you have not, log in as “Administrator” or a user whose access right is “ADMINISTRATOR”

or “OPERATOR.”)

3. Run the below command from a CLI to configure settings. (For details, refer to “Commands.”)

 Configuring a user‟s password of DianaScope (Required for using DianaScope)

The following command configures the user‟s password of DianaScope Gateway of the

blade enclosure on which this EM card is installed. (This user‟s password is also used as the

authentication key of DianaScope Manager.)

The password can contain up to 16 alphanumeric characters. (The default value of the

password is “guest.”)

SET DSGPASSWORD <the password>

4. Run the following command on the CLI to confirm the configuration.

(For details, refer to “Commands.”)

Run the SHOW DSGPASSWORD command.

TIPS:

Running “SHOW DSGSGATE” enables to confirm the availability of DianaScope Gateway.

DianaScope Gateway is made available by default. If DianaScope Gateway is unavailable, run “SET

DSGSTATE” command to make DianaScope Gateway available. (For details, refer to “Commands.”)

This completes steps to configure DianaScope.

Other settings (CPU blade)

Refer to the user‟s guide/operation manual of CPU blade.