Manualshelf

User's Guide

ManualsBrandsNEC ManualsBlade ServersNEC N8405-043 SIGMABLADE-Hv2 EM CARD
51525354555657585960
53
Checking operational status
You can check how the blade enclosure and modules on the blade enclosure are operating. The
operation status can be confirmed on the CLI of EM serial console or EM console.
Blade Enclosures
1. Confirm whether the EM card is powered on.
2. Ensure that you have logged in to the EM card on the CLI of EM serial console or EM console.
3. Run the below command from a CLI to configure settings. (For details, refer to “Commands.”)
Connecting a console to a switch module
Following command shows the statuses of the Blade Enclosure on which the EM card is
installed.
SHOW ENCLOSURE STATUS
If “Failed” is displayed, make sure that target module is installed in an appropriate slot.
When the module is installed correctly, restart the target module if possible. If the failure
persists, replace the target module.
Checking the status and temperature of a module installed on the blade enclosure
Following command shows the status and temperature of a module installed on the blade
enclosure on which the EM card is installed.
SHOW ENCLOSURE TEMP
If “Failed” is displayed, make sure that target module is installed in an appropriate slot.
When the module is installed correctly, restart the target module if possible.
If the failure persists, replace the target module.
This completes steps to check the status of the blade enclosure.
This completes the steps to check the status of the Blade Enclosure.
Fan unit
1. Confirm whether the EM card is powered on.
2. Ensure that you have logged in to the EM card on the CLI of EM serial console or EM console.
3. Run the below command from a CLI to configure settings. (For details, refer to “Commands.”)
Checking the status of a fan unit
Following command shows the status of fan unit of the blade enclosure on which the EM
card is installed.
SHOW ENCLOSURE FAN <fan unit number | ALL>
If “Failed” is displayed, make sure that the fan unit is installed in an appropriate slot. If it is
installed correctly, replace it with a spare fan unit.
This completes steps for checking the fan unit status.