User's Guide

Power unit

1. Confirm whether the EM card is powered on.

2. Ensure that you have logged in to the EM card on the CLI of EM serial console or EM console.

3. Run the below command from a CLI to configure settings. (For details, refer to “Commands.”)

 Checking the status of a fan unit

Following command shows the status of fan unit of the blade enclosure on which the EM

card is installed.

SHOW ENCLOSURE POWERSUPPLY <Power unit number | ALL>

If “Failed” is displayed, make sure that the power unit is installed in an appropriate slot.

If it is installed correctly, replace it with a spare power unit.

This completes steps for checking the power unit status.