User's Guide

62
Command Input Specifications
How to start a CLI
How to start
The EM SIGMABLADE-Hv2 firmware logs in to the EM firmware via one of the following three and
starts a CLI.
1: EM serial console
2: Telnet
3: SSH
Via the EM serial console
An EM card is equipped with a serial port to allow operation from a remote PC.
When you connect a PC to an EM card using a serial cable, the system console of the EM firmware is
displayed.
Serial cable connection parameter
Use a cross cable for a serial cable.
Transfer rate : 115200bps
Data length : 8 bit
Parity : None
Stop bit : 1 bit
Flow control : None
When connecting to the EM serial console is successful, the following window is displayed. The CLI is
started by logging in to it by a user account for CLI on the login prompt. Enter the user name that is
registered in advance and correct password to log in to the CLI.