User's Guide

68
Administrator
The following user is set by default on the CLI of EM firmware to allow system maintenance and
operation management in the initial state.
Default user
User name : “Administrator”
Access right : “ADMINISTRATOR”
Password : Admin
Usage : System maintenance/operation management
For information on password recovery, refer to “Password recovery”
CLI additional user
You can add or delete a user by using the CLI command.
You can give an added user ADMINISTRATOR, OPERATOR or USER as access right according
to the access range of the user.
There is an upper limit for the number of users that can be added.
30 users at maximum (Default user “Administrator” is included in 30 users.)
User name
Specify a user name with alphanumeric characters and symbols (to be specific, a-zA-Z, 0-9, space,
„-‟
(en dash), „_‟ (underscore)) in any combination.
The first character should be always alphabet (a-zA-Z). You can specify alphanumeric characters
for the rest of the characters.
Use 1 to 13 characters to specify user name.
Concurrent connection
The number of sessions that can be connected at the same time is limited for CLI.
The maximum number of the sessions is 17 (1+16).
1 session : Operation from the EM serial console
16 sessions : Number of CPU blades