Manualshelf

User's Guide

ManualsBrandsNEC ManualsBlade ServersNEC N8405-043 SIGMABLADE-Hv2 EM CARD
61626364656667686970
69
List of Commands
Commands
The following table shows CLI commands supported by the SIGMABLADE-Hv2 EM firmware.
Indications in the “Access rights” column
A: operation by Administrator is possible.
O: operation by Operator is possible.
U: operation by User is possible.
Indications in the “EM card active/standby” column
A: settings can be configured from the active EM
S: settings can be configured from the standby EM
Indications in the “Backup target” column
Y: configuration information that is backed up
N: configuration information that is not backed up
About “Remarks” column
A description that has asterisk “*” at the end of it means that it is a required when you restore the
configuration
* EXPRESSSCOPE engine is referred to as BMC (Baseboard Management Controller) in this
document.
* The CPU blade management commands and switch module management commands may not be
supported by some modules. (For further information, refer to the user‟s guide of each module.)
CLI commands of the SIGMABLADE-Hv2 EM firmware
Command
Access
rights
Description
Default value
EM card
active/
standby
Back
up
target
Notes
General Command
CLEAR
SCREEN
A/O/U
Clears the terminal
screen.
N/A
A/S
N
EXIT
A/O/U
Terminates the CLI.
N/A
A/S
N
HELP
A/O/U
Displays help
messages.
N/A
A/S
N
HISTORY
A/O/U
Displays the history of
the commands
entered in the CLI.
N/A
A/S
N
LOGOUT
A/O/U
Terminates the CLI.
N/A
A/S
N
QUIT
A/O/U
Terminates the CLI.
N/A
A/S
N
*3
Rack management command
SET RACK
NAME
A/O/U
Configures the name
of the EM
card-installed rack.
The rack name must
be up to 32
characters.
““
(unconfigured)
A
Y
SHOW RACK
NAME
A/O/U
Displays the name of
the configured rack
that is configured.
N/A
A/S
N
SET RACK
UID
A/O
Configures a unique
rack ID. This ID must
be up to 16
characters.
““
(unconfigured)
A
Y
*4
When unconfigured, this
will become the serial
number of the Blade
Enclosure unit
automatically.
SHOW RACK
UID
A/O/U
Displays the
rack-unique ID that
has been configured.
N/A
A/S
N
SHOW
TOPOLOGY
A/O/U
When multiple Blade
Enclosures are
installed on the same
rack, this displays the
connection status of
the Blade Enclosure.
N/A
A
N