User's Guide

7
Installation, relocation and storage of the blade enclosure
Do not install the Blade Enclosure in a place other than specified.
Do not install the blade Enclosure in a place other than specified in this guide. Avoid
following locations. There is a risk of fire.
 a dusty place
 a humid place located near a boiler, etc.
 a place exposed to direct sunlight
 an unstable place
Do not use or store the Blade Enclosure in a corrosive environment.
Avoid using or storing the Blade Enclosure in an environment with possible exposure to
corrosive gas, such as those including but not limited to: sulfur dioxide, hydrogen sulfide,
nitrogen dioxide, chlorine, ammonia and/or ozone. Avoid installing the Blade Enclosure in
a dusty environment or that may be exposed to corrosive materials such as sodium
chloride and/or sulfur.
Avoid installing the Blade Enclosure in an environment that may have excessive metal
flakes or conductive particles in the air.
Such environments may cause corroding or short circuits within the Blade Enclosure,
resulting in not only damage to the Blade Enclosure, but may also lead to a fire hazard.
If there are any concerns regarding the environment at the planned site of installation or
storage, please contact your sales representative.
Do not use any unauthorized interface cable.
Use only the interface cables provided by NEC and locate a proper device and connector
before connecting a cable. Using an unauthorized cable or connecting a cable on an
improper destination may cause a short circuit, resulting in a fire.
Also, observer the following notes on using and connecting an interface cable.
 Do not use any damaged cable connector.
 Do not use any damaged cable.
 Do not step on the cable.
 Do not place any object on the cable.
 Do not use the server with loose cable connections.
Be careful not to hurt your fingers.
Precaution required to avoid pinching your fingers when installing or removing the blade
server into or from a rack cabinet.