User's Guide

72
Command
Access
rights
Description
Default value
EM card
active/
standby
Back
up
target
Notes
REMOVE
NETWORK
DNS
A/O
Removes the IP
address of a DNS
server from the list.
N/A
A
N
*3
REMOVE
TRUSTED
HOST
A/O
Removes an IP
address that is
configured by the
“ADD TRUSTED
HOST” command.
N/A
A
N
*3
REMOVE
SNMP
TRAPRECEIV
ER
A/O
Removes a registered
SNMP trap
destination.
N/A
A
N
*3
SET
NETOWRK
ADDRESSRA
NGE
A/O
Configures IP
addresses of EM
cards, CPU blades,
and switch modules.
Refer to
“Command
specification”
A
Y
*3
SET
NETWORK
DOMAIN
A/O
Configures a domain
name. The domain
name must be up to
64 characters.
““
(unconfigured)
A
Y
*3
SET
NETWORK
GATEWAY
A/O
Configures the
gateway address of
EM cards, CPU
blades and switch
modules.
“0.0.0.0”
A
Y
*3
SET
NETWORK
NTP POLL
A/O
Configures NTP
polling intervals in
seconds.
Range of value to be
configured: 60 - 9999
“720”
A
Y
*3
SET
NETWORK
NTP
PRIMARY
A/O
Configures the IP
address of the primary
NTP server.
“0.0.0.0”
A
Y
*3
SET
NETWORK
NTP
SECONDARY
A/O
Configures the IP
address of the
secondary NTP
server.
“0.0.0.0”
A
Y
*3
SET SNMP
COMMUNITY
READ
A/O
Configures the
community name for
the read SNMP
community.
The community name
must be up to 32
characters.
“public”
A
Y
*3
SET SNMP
COMMUNITY
WRITE
A/O
Configures the
community name for
the read/write SNMP
community.
The community name
must be up to 32
characters.
“public”
A
Y
*3
SET SNMP
COMMUNITY
TRAP
A/O
Configures the
community name of
an SNMP trap.
The community name
must be up to 32
characters.
“public”
A
Y
*3
SET SNMP
CONTACT
A/O
Configures a SNMP
contact name.
The contact name
must be up to 64
characters.
“unknown”
A
Y
*3
SET SNMP
LOCATION
A/O
Configures a SNMP
location information.
The location
information must be
up to 64 characters.
“unknown”
A
Y
*3
SET SNMP
LOCATION
ENCLOSURE
A/O
Configures the blade
enclosure location in
the rack in the unit of
“EIA U”.
“0”
A
Y
*3
SET SNMP
RACKHEIGH
T
A/O
Configures the rack
height in the rack in
the unit of “EIA U”.
“0”
A
Y
*3