User's Guide

75
Command
Access
rights
Description
Default value
EM card
active/
standby
Back
up
target
Notes
SHOW
ENCLOSURE
POWERSUPP
LY
A/O/U
Displays the
information of the
power unit(s) on the
Blade Enclosure.
Display Items:
The status of power
unit
AC input status
Output capacity
Input voltage range
Input frequency
range
Parts number
Serial number
Revision
The status of power
saving
N/A
A
N
SHOW
ENCLOSURE
STATUS
A/O/U
Displays the status of
the Blade Enclosure.
Display Items:
Operating status
ID LED status
Power status capacity
N/A
A
N
SHOW
ENCLOSURE
TEMP
A/O/U
Displays the
temperature of the
Blade Enclosure.
Display Items:
Status (OK, warm,
degraded, or failed)
Temperature (in
Celsius/Fahrenheit)
N/A
A
N
SHOW
POWER
A/O/U
Displays the settings
on power
management function.
Display Items:
Power redundancy
mode
Suppliable power
capacity
Allocated power
capacity
Status of power
saving
Maximum
Consumable Power
N/A
A
N
SHOW
VERSION
A/O/U
Displays the version
of EM card/EM
firmware.
N/A
A/S
N
UPDATE
IMAGE
A
Updates the EM
firmware.
This command
downloads the EM
firmware image from
the specified URL
(http, ftp, tftp), and
use it to update the
EM firmware
automatically.
After that, the EM
firmware
automatically reboots
to apply the updated
image.
N/A
A
N
*3
UPLOAD
CONFIG
A
Uploads the
configuration
information of the EM
firmware to the URL
specified.
N/A
A
N
*3
SET POWER
SAVINGS
A/O
Configures the power
saving mode of the
power control
function.
“ON”
(always
Enable)
A
Y
*3
SET POWER
LIMIT
A/O
Configures the
maximum power
consumption for each
enclosure.
“OFF”
(Disable)
A
Y
*3