User's Guide

87
User management commands
Adding a user
Overview
Adding a user who controls and manages the system.
Up to 30 users can be registered. Note that “Administrator” is included in this 30 users.
Command name
ADD USER
First Argument
<User name>
Specify a user name within 13 characters.
TIPS:
Alphanumeric characters and some symbols (a-zA-Z, 0-9, blank, „-‟ (hyphen), „_‟ (underscore))
can be used for the same user.
Make sure to use an alphabet (a-zA-Z) for the first character. For the following characters, use
alphanumeric characters.
The length of <User name> should be from 1 to 13 characters.
Second Argument
<Password>
Specify a password by using 3 to 8 alphanumeric characters.
When you choose not to configure a password for the user, a message prompting you to enter a
password appears. The message waits for entry of a password.
Execution example
Example of execution of the command to add a user
Default value
Supplementary information
Only users with the ADMINISTRATOR rights can use this command.
Remarks of CLI command list show the detail of access rights.