User Guide

72
Commands
Commands
The following table shows CLI commands supported by the SIGMABLADE-H EM firmware.
Indications in the Access right column
A: operation by Administrator is possible.
O: operation by Operator is possible.
U: operation by User is possible.
Indications in EM card active/standby column
A: settings can be configured from the active EM
S: settings can be configured from the standby EM
Indications in backup target column
Y: configuration information that can be backed up
N : configuration information that cannot be backed up
CLI commands of the SIGMABLADE-H EM firmware
Command
Access
right
Description
Default value
EM card
active/standby
Backup
target
Remarks
Switch module management command
POWEROFF
SWITCH
A/O
Shuts down the DC power of the
specified switch module.
N/A
A
N
POWERON
SWITCH
A/O
Powers on the DC of the
specified switch module.
N/A
A
N
RESTART
SWITCH
A/O
Restarts the specified switch
module.
N/A
A
N
SET SWITCH
NAME
A/O
Names the specified switch
module.
(depends on
the switch
module)
A
N
SET SWITCH
UID
A/O/U
Lights on and off the ID LED of
the specified switch module
N/A
A
N
SHOW SWITCH
INFO
A/O/U
Displays the information on the
specified switch module.
Information to be displayed:
Switch module type
Manufacturer‟s name
Product name
Product part number
Product version
Product serial number
N/A
A
N
SHOW SWITCH
LIST
A/O/U
Lists installed switch modules.
N/A
A
N
SHOW SWITCH
PORT MAP
A/O/U
Displays the port mapping
information for the specified
switch module.
N/A
A
N
SHOW SWITCH
STATUS
A/O/U
Displays the statuses of the
specified switch module
Information to be displayed:
ID LED status
Operational status
N/A
A
N
* “Information to be displayed” indicates key information to be displayed.