Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Smart Panel Reference Guide 31
Information Menu
Introduction
You can view configuration information for the switch in the user, operator, and administrator command modes.
This chapter discusses how to use the CLI to display switch information.
Menu overview
Command: /info
[Information Menu]
sys - System Information Menu
l2 - Layer 2 Information Menu
l3 - Layer 3 Information Menu
link - Show link status
port - Show port information
group - Show group information
dump - Dump all information
The following table describes the Information Menu options.
Table 15 Information Menu options
Command
Usage
sys
Displays system information.
l2
Displays the Layer 2 Information Menu.
l3
Displays the Layer 3 Information Menu.
link
Displays configuration information about each port, including:
Port number
Port speed (10 Mb/s, 100 Mb/s, 1000 Mb/s, or any)
Duplex mode (half, full, or any)
Flow control for transmit and receive (no, yes, or any)
Link status (up or down)
port
Displays port status information, including:
Port number
Port name
VLAN membership
group
Displays the group information
dump
Dumps all switch information available from the Information Menu (10K or more, depending on
your configuration).
If you want to capture dump data to a file, set your communication software on your workstation
to capture session data prior to issuing the dump commands.