Command Reference Guide

Command Reference Guide (ISCLI) Command Reference Guide (ISCLI) 101
Operations Commands
Introduction
Operations-level commands are used for making immediate and temporary changes to switch configuration.
Operations commands are used for bringing ports temporarily in and out of service. These commands are available
only from an administrator and operator login.
The following table describes basic Operations commands. The following sections provide more detailed
information and commands.
Table 120 Operations commands
Command
Description
password
Allows the user to change the password. You need to enter the current password in
use for validation.
Command mode: All
clear logging
Clears all Syslog messages. This command is available only from an administrator
login.
Command mode: Privileged EXEC
ntp send
Allows the user to send requests to the NTP server. This command is available
only from an administrator login.
Command mode: Privileged EXEC
Operations-level port options
Operations-level port options are used for temporarily disabling or enabling a port.
Table 121 Operations-Level Port commands
Command
Description
[no] interface
gigabitethernet <port
number> rmon
Enables or disables Remote Monitoring for the port. RMON must be enabled
for any RMON configurations to function.
Command mode: All
no interface
gigabitethernet <port
number> shutdown
Temporarily enables the port. The port will be returned to its configured
operation mode when the switch is reloaded.
Note: This command does not enable a port that has been disabled by an
ekeying mismatch error.
Command mode: All
interface gigabitethernet
<port number> shutdown
Temporarily disables the port. The port will be returned to its configured
operation mode when the switch is reloaded.
Command mode: All
show interface
gigabitethernet <port
number> operation
Displays the current settings for the port.
Command mode: All