Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 100
IGMP configuration
Command: /cfg/l3/igmp
[IGMP Menu]
snoop - IGMP Snoop Menu
mrouter - Static Multicast Router Menu
igmpflt - IGMP Filtering Menu
on - Globally turn IGMP ON
off - Globally turn IGMP OFF
cur - Display current IGMP configuration
IGMP Snooping allows the switch to forward multicast traffic only to those ports that request it. IGMP Snooping
prevents multicast traffic from being flooded to all ports. The switch learns which server hosts are interested in
receiving multicast traffic, and forwards it only to ports connected to those servers.
The following table describes the IGMP Menu options.
Table 105 IGMP Snoop Menu options
Command
Description
snoop
Displays the IGMP Snoop Menu.
mrouter
Displays the Static Multicast Router Menu.
igmpflt
Displays the IGMP Filtering Menu.
on
Globally turns IGMP on.
off
Globally turns IGMP off. This is the default.
cur
Displays the current IGMP configuration parameters.
IGMP snooping configuration
Command: /cfg/l3/igmp/snoop
[IGMP Snoop Menu]
timeout - Set report timeout
mrto - Set multicast router timeout
qintrval - Set IGMP query interval
robust - Set expected packet loss on subnet
aggr - Aggregate IGMP report
srcip - Set source ip to use when proxying GSQ
add - Add VLAN(s) to IGMP Snooping
rem - Remove VLAN(s) from IGMP Snooping
clear - Remove all VLAN(s) from IGMP Snooping
fastlv - Enable/disable Fastleave processing in VLAN
cur - Display current IGMP Snooping configuration
The following table describes the IGMP Snoop Configuration Menu options.
Table 106 IGMP Snoop Menu options
Command
Description
timeout <1-255>
Sets the Maximum Response Time (MRT) for IGMP hosts. MRT is one of the
parameters used to determine the age out period of the IGMP hosts. Increasing the
timeout increases the age out period.
The range is from 1 to 255 seconds. The default is 10 seconds
mrto <1-600>
Configures the age-out period for the IGMP Mrouters in the Mrouter table. If the
switch does not receive a General Query from the Mrouter for mrto seconds, the
switch removes the multicast router from its Mrouter table.
The range is from 1 to 600 seconds. The default is 255 seconds.
qintrval <1-600>
Sets the IGMP router query interval. The range is 1-600 seconds. The default value
is 125.
robust <2-10>
Configures the IGMP Robustness variable, which allows you to tune the switch for
expected packet loss on the subnet. If the subnet is expected to be lossy (high rate
of packet loss), then increase the value. The default value is 2.
aggr disable|enable
Enables or disables IGMP Membership Report aggregation. The default is enabled.
srcip <IP address>
Configures the source IP address used as a proxy for IGMP Group Specific
Queries.
add <1-4094>
Adds the VLAN to IGMP Snooping.
rem <1-4094>
Removes the VLAN from IGMP Snooping.