Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 108
The following table describes the Uplink Failure Detection (UFD) Configuration Menu options.
Table 118 Uplink Failure Detection Configuration Menu options
Command
Description
fdp <FDP number>
Displays the Failure Detection Pair menu.
on
Globally turns Uplink Failure Detection ON.
off
Globally turns Uplink Failure Detection OFF. This is the default.
cur
Displays the current Uplink Failure Detection configuration parameters.
Failure Detection Pair configuration
Command: /cfg/ufd/fdp <FDP number>
[FDP 1 Menu]
ltm - Link to Monitor Menu
ltd - Link to Disable Menu
ena - Enable FDP
dis - Disable FDP
current - Display current FDP configuration
Use these commands to configure a Failure Detection Pair, which consists of one Link to Monitor (LtM) and one
Link to Disable (LtD). When the switch detects a failure on the LtM, it automatically disables the ports in the LtD.
The following table describes the Failure Detection Pair (FDP) configuration Menu options.
Table 119 Failure Detection Pair Configuration Menu options
Command
Description
ltm
Displays the Links to Monitor menu.
ltd
Displays the Links to Disable menu.
ena
Enables the FDP Parameters.
dis
Disables the FDP Parameters. This is the default.
current
Displays the current FDP configuration.
Link to Monitor configuration
Command: /cfg/ufd/fdp <FDP number>/ltm
[Failure Link to Monitor Menu]
addport - Add port to Link to Monitor
remport - Remove port from Link to Monitor
addtrnk - Add trunk to Link to Monitor
remtrnk - Remove trunk from Link to Monitor
addkey - Add adminkey to Link to Monitor
remkey - Remove adminkey from Link to Monitor
cur - Display current LtM configuration
The following table describes the Link to Monitor (LtM) Menu options. The LtM can consist of only one uplink port
(ports 20-24), a single trunk containing only uplink ports, or a single LACP trunk group containing only uplink ports.
Table 120 Link to Monitor Menu options
Command
Description
addport <port number>
Adds a port to the LtM. Only uplink ports (20-24) are allowed in the LtM.
remport <port number>
Removes a port from the LtM.
addtrnk <1-12>
Adds a trunk group to the LtM. The LtM trunk group can contain only uplink ports
(20-24).
remtrnk <1-12>
Removes a trunk group from the LtM.
addkey <LACP port
adminkey>
Adds a LACP trunk group to the LtM. The LtM LACP trunk group can contain only
uplink ports (20-24).
remkey <LACP port
adminkey>
Removes a LACP trunk group from the LtM.
cur
Displays the current LtM configuration.