Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 19
Information Menu
Introduction
You can view configuration information for the switch in the user, operator, and administrator command modes.
This chapter discusses how to use the CLI to display switch information.
Menu overview
Command: /info
[Information Menu]
sys - System Information Menu
l2 - Layer 2 Information Menu
l3 - Layer 3 Information Menu
rmon - Show RMON information
link - Show link status
port - Show port information
geaport - Show system port and gea port mapping
ufd - Show Uplink Failure Detection information
dump - Dump all information
The following table describes the Information Menu options.
Table 6 Information Menu options
Command
Usage
sys
Displays system information.
l2
Displays the Layer 2 Information Menu.
l3
Displays the Layer 3 Information Menu.
rmon
Displays the Remote Monitoring Information Menu.
link
Displays configuration information about each port, including:
Port number
Port speed (10 Mb/s, 100 Mb/s, 1000 Mb/s, or any)
Duplex mode (half, full, or any)
Flow control for transmit and receive (no, yes, or any)
Link status (up or down)
port
Displays port status information, including:
Port number
Whether the port uses VLAN tagging or not
Port VLAN ID (PVID)
Port name
VLAN membership
geaport
Displays GEA port mapping information, used by service personnel.
ufd
Displays Uplink Failure Detection information
dump
Dumps all switch information available from the Information Menu (10K or more, depending on
your configuration).
If you want to capture dump data to a file, set your communication software on your workstation
to capture session data prior to issuing the dump commands.