Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 66
Configuration Menu
Introduction
The Configuration Menu is only available from an administrator login. It includes submenus for configuring every
aspect of the switch. Changes to configuration are not active until explicitly applied. Changes can be saved to flash
memory.
Menu information
Command: /cfg
[Configuration Menu]
sys - System-wide Parameter Menu
port - Port Menu
l2 - Layer 2 Menu
l3 - Layer 3 Menu
rmon - RMON Menu
pmirr - Port Mirroring Menu
ufd - Uplink Failure Detection Menu
dump - Dump current configuration to script file
ptcfg - Backup current configuration to FTP/TFTP server
gtcfg - Restore current configuration from FTP/TFTP server
cur - Display current configuration
The following table describes the Configuration Menu options.
Table 61 Configuration Menu options
Command
Usage
sys
Displays the System Configuration Menu.
port <port number>
Displays the Port Configuration Menu.
l2
Displays the Layer 2 Configuration Menu.
l3
Displays the Layer 3 Configuration Menu.
rmon
Displays the RMON Configuration Menu.
pmirr
Displays the Mirroring Configuration Menu.
ufd
Displays the Uplink Failure Detection Configuration Menu.
dump
Dumps current configuration to a script file.
ptcfg <host name or IP address of
FTP/TFTP server> <filename on host>
Backs up current configuration to FTP/TFTP server.
gtcfg <host name or IP address of
FTP/TFTP server> <filename on host>
Restores current configuration from FTP/TFTP server.
cur
Displays the current configuration parameters.
Viewing, applying, reverting, and saving changes
As you use the configuration menus to set switch parameters, the changes you make do not take effect
immediately. All changes are considered pending until you explicitly apply them. Also, any changes are lost the
next time the switch boots unless the changes are explicitly saved.
While configuration changes are in the pending state, you can:
View the pending changes
Apply the pending changes
Revert to restore configuration parameters set with the last apply command
Save the changes to flash memory