Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 69
Table 62 System Configuration Menu options
Command
Usage
dlight disable|enable
Disables or enables daylight saving time in the system clock. When
enabled, the switch will add an extra hour to the system clock so
that it is consistent with the local clock. By default, this option is
disabled.
idle <1-60>
Sets the idle timeout for CLI sessions, from 1 to 60 minutes. The
default is 5 minutes.
This setting affects both the console port and Telnet port.
notice <1-1024 character multi-
line> <'-' to end>
Displays login notice immediately before the ―Enter password:‖
prompt. This notice can contain up to 1024 characters and new
lines.
bannr <1-80 characters>
Configures a login banner of up to 80 characters. When a user or
administrator logs into the switch, the login banner is displayed. It is
also displayed as part of the output from the /info/sys/gen
command.
hprompt disable|enable
Enables or disables displaying of the host name (system
administrator‘s name) in the command line interface.The default
value is disabled.
bootp disable|enable
Enables or disables the use of BOOTP. If you enable BOOTP, the
switch will query its BOOTP server for setting the IP parameters on
interface 1. The IP address obtained from the BOOTP server
overrides the static IP address. The default value is enabled.
dhcp disable|enable
Enables or disables Dynamic Host Control Protocol for setting the
management IP address on interface 256. When enabled, the IP
address obtained from the DHCP server overrides the static IP
address. The default value is enabled.
reminders disable|enable
Enables or disables reminder messages in the CLI. The default
value is enabled.
cur
Displays the current system parameters.
System host log configuration
Command: /cfg/sys/syslog
[Syslog Menu]
host - Set IP address of first syslog host
host2 - Set IP address of second syslog host
sever - Set the severity of first syslog host
sever2 - Set the severity of second syslog host
facil - Set facility of first syslog host
facil2 - Set facility of second syslog host
console - Enable/disable console output of syslog messages
log - Enable/disable syslogging of features
cur - Display current syslog settings
The following table describes the Syslog Configuration Menu options.
Table 63 Syslog Configuration Menu options
Command
Description
host <IP address>
Sets the IP address of the first syslog host. For example,
100.10.1.1
host2 <IP address>
Sets the IP address of the second syslog host. For
example,
100.10.1.2
sever <1-7>
Sets the severity level of the first syslog host displayed.
The default is 7, which means log all the severity levels.
sever2 <1-7>
Sets the severity level of the second syslog host displayed.
The default is 7, which means log all the severity levels.
facil <1-7>
This option sets the facility level of the first syslog host
displayed. The range is 0-7. The default is 0.
facil2 <1-7>
This option sets the facility level of the second syslog host
displayed. The range is 0-7. The default is 0.