Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 74
NTP server configuration
Command: /cfg/sys/ntp
[NTP Server Menu]
prisrv - Set primary NTP server address
secsrv - Set secondary NTP server address
intrval - Set NTP server resync interval
on - Turn NTP service ON
off - Turn NTP service OFF
cur - Display current NTP configuration
This menu enables you to synchronize the switch clock to a Network Time Protocol (NTP) server. By default, this
option is disabled.
The following table describes the NTP Server Configuration Menu options.
Table 67 NTP Server Configuration Menu options
Command
Description
prisrv <IP address>
Configures the IP addresses of the primary NTP server to which you want to
synchronize the switch clock.
secsrv <IP address>
Configures the IP addresses of the secondary NTP server to which you want to
synchronize the switch clock.
intrval <1-44640>
Specifies the interval, that is, how often, in minutes (1-44640), to resynchronize
the switch clock with the NTP server. The default is 1440 minutes.
on
Enables the NTP synchronization service.
off
Disables the NTP synchronization service. This is the default.
cur
Displays the current NTP service settings.
System SNMP configuration
Command: /cfg/sys/ssnmp
[SNMP Menu]
snmpv3 - SNMPv3 Menu
name - Set SNMP "sysName"
locn - Set SNMP "sysLocation"
cont - Set SNMP "sysContact"
rcomm - Set SNMP read community string
wcomm - Set SNMP write community string
timeout - Set timeout for the SNMP state machine
auth - Enable/disable SNMP "sysAuthenTrap"
linkt - Enable/disable SNMP link up/down trap
ufd - Enable/disable SNMP Uplink Failure Detection trap
cur - Display current SNMP configuration
The switch software supports SNMP-based network management. In SNMP model of network management, a
management station (client/manager) accesses a set of variables known as MIBs (Management Information Base)
provided by the managed device (agent). If you are running an SNMP network management station on your
network, you can manage the switch using the following standard SNMP MIBs:
MIB II (RFC 1213)
Ethernet MIB (RFC 1643)
Bridge MIB (RFC 1493)