Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 84
HTTPS Access configuration
Command: /cfg/sys/access/https
[https Menu]
access - Enable/Disable HTTPS Web access
port - HTTPS WebServer port number
generate - Generate self-signed HTTPS server certificate
certSave - save HTTPS certificate
cur - Display current SSL Web Access configuration
The following table describes the HTTPS Access Configuration menu options.
Table 82 HTTPS Access Configuration menu options
Command
Description
access enable|disable
Enables or disables BBI access (Web access) using HTTPS. The default value is
disabled.
port <TCP port number>
Defines the HTTPS Web server port number. The default is 443.
generate
Allows you to generate a certificate to connect to the SSL to be used during the key
exchange. A default certificate is created when HTTPS is enabled for the first time.
The user can create a new certificate defining the information that they want to be
used in the various fields. For example:
Country Name (2 letter code) [ ]: JP
State or Province Name (full name) [ ]: Tokyo
Locality Name (for example, city) [ ]: Fuchu
Organization Name (for example, company) [ ]: NEC
Organizational Unit Name (for example, section) [ ]: SIGMABLADE
Common Name (for example, user‘s name) [ ]: Taro
Email (for example, email address) [ ]: [e-mail]
You must confirm if you want to generate the certificate. It takes approximately
30 seconds to generate the certificate. Then the switch restarts SSL agent.
certSave
Allows the client, or the Web browser, to accept the certificate and save the
certificate to Flash to be used when the switch is rebooted.
cur
Displays the current SSL Web Access configuration.
Port configuration
Command: /cfg/port <port number>
[Port 1 Menu]
gig - Gig Phy Menu
pvid - Set default port VLAN id
name - Set port name
rmon - Enable/Disable RMON for port
tag - Enable/disable VLAN tagging for port
tagpvid - Enable/disable tagging on pvid
ena - Enable port
dis - Disable port
cur - Display current port configuration
This menu enables you to configure settings for individual switch ports. This command is enabled by default.
NOTE: Port 19 is a port for switch management interface (interface 256).