Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 85
The following table describes the Port Configuration Menu options.
Table 83 Port Configuration Menu options
Command
Description
gig
Displays theGigabit Ethernet Physical Link Menu.
pvid <1-4095>
Sets the default VLAN number which will be used to forward frames
which are not VLAN tagged. The default number for all ports except
Port 19 is 1.
Note: VLAN 4095 is a VLAN for switch management interface.
name <1-64 characters>|none
Sets a name for the port (maximum 64 characters). The assigned port
name displays next to the port number on some information and
statistics screens.
rmon enable|disable
Enables or disables Remote Monitoring for the port. The default is
disabled. RMON must be enabled for any RMON configurations to
function.
tag enable|disable
Disables or enables VLAN tagging for this port. The default is disabled.
tagpvid enable|disable
Disables or enables VLAN tag persistence. When disabled, the VLAN
tag is removed from packets whose VLAN tag matches the port PVID.
The default value is enabled.
ena
Enables the port.
dis
Disables the port. To temporarily disable a port without changing its
configuration attributes, see the ―Temporarily disabling a port‖ section
later in this chapter.
cur
Displays current port parameters.
Temporarily disabling a port
To temporarily disable a port without changing its stored configuration attributes, enter the following command at
any prompt:
Main# /oper/port <port number>/dis
Because this configuration sets a temporary state for the port, you do not need to use apply or save. The port state
will revert to its original configuration when the switch is reset. See the ―Menu information‖ section in the
―Operations Menu‖ chapter for other operations-level commands.
Port link configuration
Command: /cfg/port <port number>/gig
[Gigabit Link Menu]
speed - Set link speed
mode - Set full or half duplex mode
fctl - Set flow control
auto - Set auto negotiation
cur - Display current gig link configuration
Use these menu options to set port parameters for the port link.
Link menu options are described in the following table and display on the Gigabit port configuration menus for the
switch. Using these configuration menus, you can set port parameters such as speed, duplex, flow control, and
negotiation mode for the port link.