Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 93
Table 92 Spanning Tree Port Configuration Menu options
Command
Description
edge disable|enable
Enables or disables this port as an edge port. An edge port is not connected to a
bridge, and can begin forwarding traffic as soon as the link is up. Configure server
ports as edge ports (enabled). By default, Ports 1-16 are configured as edge
ports.
This command only applies when RSTP is turned on. See the ―Common Internal
Spanning Tree configuration‖ section for more information.
fastfwd disable|enable
Enables or disables Port Fast Forward on the port. The default is disabled.
on
Enables STP on the port. This is the default for Ports 17-18 and 20-24.
off
Disables STP on the port.
cur
Displays the current STP port parameters.
Forwarding Database configuration
Command: /cfg/l2/fdb
[FDB Menu]
static - Static FDB Menu
aging - Configure FDB aging value
cur - Display current FDB configuration
The following table describes the Forwarding Database Configuration Menu options.
Table 93 FDB Configuration Menu options
Command
Description
static
Displays the Static FDB Configuration Menu.
aging <0-65535>
Configures the aging value for FDB entries. The default value is 300.
cur
Displays current FDB parameters.
Static FDB configuration
Command: /cfg/l2/fdb/static
[Static FDB Menu]
add - Add a permanent FDB entry
del - Delete a static FDB entry
clear - Clear static FDB entries
cur - Display current static FDB configuration
The following table describes the Static FDB Configuration Menu options.
Table 94 Static FDB Configuration Menu options
Command
Description
add <MAC address> <VLAN> <port>
Adds a static entry to the forwarding database.
del <MAC address> <VLAN> <port>
Deletes a static entry from the forwarding database.
clear mac <MAC Address>|VLAN <1-4095>|
Port <port number>|All
Clears specified static FDB entries from the forwarding
database,
as follows:
MAC address
VLAN
Port
All
cur
Displays current static FDB parameters.
Trunk configuration
Command: /cfg/l2/trunk <1-12>