Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 94
[Trunk group 1 Menu]
add - Add port to trunk group
rem - Remove port from trunk group
ena - Enable trunk group
dis - Disable trunk group
del - Delete trunk group
cur - Display current Trunk Group configuration
Trunk groups can provide super-bandwidth connections between switches or other trunk capable devices. A trunk
is a group of ports that act together, combining their bandwidth to create a single, larger port. Up to 12 trunk groups
can be configured on the switch, with the following restrictions.
Any physical switch port can belong to no more than one trunk group.
Up to six ports/trunks can belong to the same trunk group.
All ports in a trunk must have the same configuration for speed, flow control, and auto negotiation.
Trunking from other devices must comply with Cisco® EtherChannel® technology.
By default, port 17 and port 18 are trunked to support an internal switch-to-switch crosslink trunk. By default,
ports 17 and 18 are disabled.
NOTE: See the Application Guide for information on how to use port trunks.
The following table describes the Trunk Group Configuration Menu options.
Table 95 Trunk Group Configuration Menu options
Command
Description
add <port number>
Adds a physical port to the current trunk group.
rem <port number>
Removes a physical port from the current trunk group.
ena
Enables the current trunk group.
dis
Turns the current trunk group off.
del
Removes the current trunk group configuration.
cur
Displays current trunk group parameters.
IP Trunk Hash configuration
Command: /cfg/l2/thash
[IP Trunk Hash Menu]
set - IP Trunk Hash Settings Menu
cur - Display current IP trunk hash configuration
The following table describes the IP Trunk Hash Configuration Menu options.
Table 96 IP Trunk Hash Configuration Menu options
Command
Description
set
Displays the Trunk Hash Settings menu.
cur
Display current trunk hash configuration.
Layer 2 IP Trunk Hash configuration
Command: /cfg/l2/thash/set
[set IP Trunk Hash Settings Menu]
smac - Enable/disable smac hash
dmac - Enable/disable dmac hash
sip - Enable/disable sip hash
dip - Enable/disable dip hash
cur - Display current trunk hash setting
Trunk hash parameters are set globally for the switch. You can enable one or two parameters, to configure any of
the following valid combinations:
SMAC (source MAC only)
DMAC (destination MAC only)
SIP (source IP only)