Command Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS) 95
DIP (destination IP only)
SIP + DIP (source IP and destination IP)
SMAC + DMAC (source MAC and destination MAC)
The following table describes the IP Trunk Hash Configuration Menu options.
Table 97 IP Trunk Hash Set Menu options
Command
Description
smac enable|disable
Enable or disable trunk hashing on the source MAC.
dmac enable|disable
Enable or disable trunk hashing on the destination MAC.
sip enable|disable
Enable or disable trunk hashing on the source IP.
dip enable|disable
Enable or disable trunk hashing on the destination IP.
cur
Display current trunk hash configuration.
Link Aggregation Control Protocol configuration
Command: /cfg/l2/lacp
[LACP Menu]
sysprio - Set LACP system priority
timeout - Set LACP system timeout scale for timing out partner info
port - LACP port Menu
cur - Display current LACP configuration
The following table describes the LACP Configuration Menu options.
Table 98 LACP Configuration Menu options
Command
Description
sysprio <1-65535>
Defines the priority value (1 through 65535) for the switch. Lower numbers
provide higher priority. The default value is 32768.
timeout short|long
Defines the timeout period before invalidating LACP data from a remote
partner. Choose short (3 seconds) or long (90 seconds). The default
value is long.
Note: We recommends that you use a timeout value of long, to reduce
LACPDU processing. If your switch‘s CPU utilization rate remains at 100% for
periods of 90 seconds or more, consider using static trunks instead of LACP.
port <port number>
Displays the LACP Port menu.
cur
Display current LACP configuration.
LACP Port configuration
Command: /cfg/l2/lacp/port <port number>
[LACP Port 2 Menu]
mode - Set LACP mode
prio - Set LACP port priority
adminkey - Set LACP port admin key
cur - Display current LACP port configuration
The following table describes the LACP Port Configuration Menu options.
Table 99 LACP Port Configuration Menu options
Command
Description
mode off|active|passive
Set the LACP mode for this port, as follows:
off
Turn LACP off for this port. You can use this port to manually configure a
static trunk. The default value is off.
active
Turn LACP on and set this port to active. Active ports initiate LACPDUs.
passive
Turn LACP on and set this port to passive. Passive ports do not initiate
LACPDUs, but respond to LACPDUs from active ports.
prio <1-65535>
Sets the priority value for the selected port. Lower numbers provide higher
priority. Default is 32768.