Manualshelf

Reference Guide

ManualsBrandsNEC ManualsSwitchN8406-022A
81828384858687888990
N8406-022A 1Gb Intelligent L2 Switch Browser-based Interface Reference Guide 84
Table 66 Switch Image and Configuration Management controls
Control
Description
Username for FTP server of Blank for TFTP
Server
Enter the user name, if you want to upload to the FTP server. Remain
the blank, if you want to upload to the TFTP server.
Password for FTP server
Enter the password for the FTP server.
Image Settings
Image for Transfer
Selects a software image to replace with the downloaded software.
Image Filename (on server)
Enter the name of the file on a FTP/TFTP server that contains the
software image you want to download.
Image Filename (on HTTP Client)
Enter the name of the file on an HTTP Client that contains the software
image you want to download.
Config/Dump Settings
Configuration Filename
Selects the file name and location of the Configuration Block file to be
downloaded.
TS Dump Filename
Selects the filename for the TS (tech support) dump that you want to
upload to the FTP/TFTP server.
Flash Dump Filename
Selects the filename for the core (PANIC) dump that you want to upload
to the FTP/TFTP server.
Status of Previous Transfer
Displays the status of the previous software download attempt.
Switch Image and Configuration Management buttons
The following table describes Switch Image and Configuration Management buttons:
Table 67 Switch Image and Configuration Management buttons
Button
Description
Get Image
Starts download of the software image file indicated in FTP/TFTP Image Filename
field from the specified TFTP server.
Put Image
Starts upload of the software image file indicated in FTP/TFTP Image Filename
field from the specified TFTP server.
Get Config
Downloads a previously saved switch Configuration Block file indicated in
Configuration Filename from the specified the FTP/TFTP server.
The active configuration will be replaced with the commands found in the
downloaded configuration file. The file can contain a full switch configuration or a
partial switch configuration.
The new configuration is not activated until the apply command is used. If the apply
command is found in the configuration script file loaded using this command, the
apply action is performed automatically.
Put Config
Uploads the switch‟s active configuration to the script configuration file specified in
Configuration Filename. The file is placed on the FTP/TFTP server.
Put TS Dump
Uploads the TS (tech support) dump file to the FTP/TFTP server specified in TS
Dump Filename.
Put Dump
Uploads the core (PANIC) dump file to the FTP/TFTP server specified in Core
Dump Filename.
Clear Flash Dump
Deletes the core dump in flash memory.
Submit
When selected, the form is sent to the switch. Any configuration changes are
placed in the “pending” state and do not take effect until the toolbar Apply
command is given.
REBOOT!
Reboots the switch.