Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Browser-based Interface Reference Guide 87
The following table describes the Switch Port Configuration controls:
Table 69 Switch Port Configuration controls
Control
Description
Switch Port State
Enables or disables the port.
RMON Instrumentation
Enables or disables Remote Monitoring for the port. RMON must be
enabled for RMON statistics and history sampling to function.
VLAN Tagging
Disables or enables VLAN tagging for this port. It is disabled by
default.
PVID Tagging
Disables or enables VLAN tag persistence. When disabled, the VLAN
tag is removed from packets whose VLAN tag matches the port PVID.
The default value is enabled.
Port STP
Turns Spanning Tree On or Off for this port.
Default Port VLAN ID (1-4095)
Sets the default VLAN number which will be used to forward frames
which are not VLAN tagged.
The default number is 1.
Note: VLAN 4095 is reserved for switch management.
Flow Control
Sets the flow control. The choices include:
Receive flow control
Transmit flow control
Both receive and transmit flow control (default)
No flow control
Autonegotiation
Enables or disables auto negotiation for the port.
Speed
Sets the link speed. Not all options are valid on all ports. The choices
include:
“Any,” for automatic detection (default)
10 Mbps
100 Mbps
1000 Mbps
Duplex mode
Sets the operating mode. Not all options are valid on all ports. The
choices include:
“Any,” for auto negotiation (default)
Full-duplex
Half-duplex
Enable/Disable sending Link UP/Down Trap
Enables or disables the sending of SNMP link up and link down traps.
The default setting is enabled.
Port Name
Sets a name for the port. The assigned port name appears next to the
port number on some information and statistics screens.