Reference Guide

N8406-022A 1Gb Intelligent L2 Switch Browser-based Interface Reference Guide 93
Switch Spanning Tree Groups Configuration
To display the following form, select Layer 2 > Spanning Tree Groups (click the underlined text, not the folder).
This form summarizes Spanning Tree Group parameters.
This switch supports the IEEE 802.1d Spanning Tree Protocol (STP) and Per VLAN Spanning Tree (PVST+).
You can configure up to 31 Spanning Tree Groups on the switch (STG 32 is reserved for switch management).
Spanning Tree is turned on by default.
NOTE: When RSTP is turned on, only STP group 1 can be configured.
The following table describes the Switch Spanning Tree Groups Configuration controls:
Table 76 Switch Spanning Tree Groups Configuration controls
Control
Description
Search Range
To search for a Spanning Tree Group, enter a range of group numbers in the From and To
fields.
Search Options
To focus the search for a Spanning Tree Group, enter optional search parameters:
Bridge Priority
Spanning Tree State
Fields that have a value of “any” are ignored during the search.
Choose a search operation:
or: Search for Spanning Tree Groups specified in the search range that meet any of the
criteria entered.
and: Search for Spanning Tree Groups specified in the search range that meet all of the
criteria entered.
Click Search to display Spanning Tree Groups that fit the range and meet the criteria entered.