User guide

(English)
29
N8406-022A
R ST
20 21 22 23 24
1
2
3
4 5
6
7
8
Description
Name
Description
1. Ejector
Use this lever to install or remove the Switch Module in/from the Blade Enclosure.
2. RESET Switch
Press this switch to restart the Switch Module.
Pressing the RESET switch reboots the Switch Module, clears the configuration data
not saved in the flash memory, and temporarily disconnects communication with the
network.
3. STATUS LED
Indicates the Switch Module status.
Contact your service representative if it does not turn green five minutes after the Blade
Enclosure is powered on.
4. ID LED
Identifies the Switch Module in the Blade Enclosure. The LED is lit by a software
command.
5. Serial Port
DB-9 management serial port.
6. LAN port
RJ-45 connectors for Gigabit Ethernet uplink.
7. LINK/ACT LED
Indicates the link status and activity of each LAN port.
Off
Link not established
On (Green)
Link established
Flash (Green)
Data being transmitted or received
8. SPEED LED
Indicates the link speed
Off
10Mbps
On (Green)
100Mbps
On (Amber)
1000Mbps
NOTE: The Switch Module is powered by the Blade Enclosure. It does
not have a POWER switch.