User guide

(English)
37
IMPORTANT:
・ The Switch Module is powered by the Blade Enclosure. The Switch
Module is powered on as soon as it is installed in the powered Blade
Enclosure. Therefore, make sure that the ports connected with the
Switch Module are only the ports of the on-board LAN and NIC on the
CPU Blade. Then, install the Switch Module in the Blade Enclosure.
・ Do not hold the ejector to install the Switch Module in the Blade
Enclosure. Hold the Switch Module itself and insert it into the Switch
Module slot. Inserting the Switch Module while holding the ejector
may damage it or cause it to break off from the Switch Module. It may
cause personal injury if the Switch Module falls.
NOTE:
・ The Switch Module does not have a POWER switch.
・ The STATUS LED turns green after 10 seconds from installing the
Switch Module in the powered Blade Enclosure.
Removal Procedure
Refer to the Blade Enclosure User’s Guide for details.
1
Open the ejector of the 1Gb Intelligent L2
Switch.
Blade Enclosure
2
Pull the ejector slightly.
Ejector