User guide

(English)
41
Selecting switch software to run
- Current boot options
To display the current boot options, enter the following:
>> # /boot/cur
Currently set to boot software image1, factory default config block:
Current FLASH software
image1: version 1.2.0, download 0:15:51 Mon Jan 2, 2006
NormalPanel
image2: version 1.0.0, download 1:32:08 Sun Jan 8, 2006
SmartPanel
boot kernel: version 1.2.0
(Display the current boot options)
NormalPanel is the L2 switch mode software, and SmartPanel is the SmartPanel mode software. By default, the
NormalPanel software is stored in image1, and the SmartPanel software is stored in image2.
- Changing the switch software to run
To change the switch software, enter the following:
>> # /boot/image
Currently there are 2 images on flash:
image1 is for NormalPanel
image2 is for SmartPanel
Currently set to use switch software “image1” on next boot.
Specify new image to use [“image1”/”image2”]: image2
Next boot will use switch software image2 instead of image1.
>> # Boot Options# /boot/reset
WARNING: Image2 is for SmartPanel!
All config regions will be cleared!
The factory config block will be used!
Please backup the active config!
Reset will use software “image2” and the factory default config block.
>> Note that this will RESTART the Spanning Tree,
>> which will likely cause an interruption in network service.
Confirm reset [y/n]: y
(Change the image the switch software
is stored)
(Enter the image to run on next boot)
(Reboot the switch)
(Enter „y‟)
IMPORTANT: When the switch software is changed and the switch is
rebooted, the switch configuration is removed and the switch runs the
factory configuration block. Backup the switch configuration if necessary.