Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (ISCLI) 136
Table 156 Ethernet Filter Configuration commands
Command
Description
default access-control list <ACL
number> ethernet
Resets Ethernet parameters for the ACL to their default
values.
Command mode: Global configuration
show access-control list <ACL number>
ethernet
Displays the current Ethernet parameters for the ACL.
Command mode: All
ACL IP Version 4 Filter configuration
These commands allow you to define IPv4 matching criteria for an ACL. The following table describes the IP
version 4 Filter Configuration commands.
Table 157 IPv4 Filter Configuration commands
Command
Description
[no] access-control list
<ACL number> ipv4 source-ip-
address <IP address> [<IP
mask>]
Defines a source IP address for the ACL. If defined, traffic with this source IP
address will match this ACL. Specify an IP address in dotted decimal notation.
Command mode: Global configuration
[no] access-control list
<ACL number> ipv4
destination-ip-address <IP
address> [<IP mask>]
Defines a destination IP address for the ACL. If defined, traffic with this
destination IP address will match this ACL.
Command mode: Global configuration
[no] access-control list
<ACL number> ipv4 protocol
<0-255>
Defines an IP protocol for the ACL. If defined, traffic from the specified
protocol matches this filter. Specify the protocol number. Listed below are
some of the well-known protocols.
Number Name
1 icmp
2 igmp
6 tcp
17 udp
89 ospf
112 vrrp
Command mode: Global configuration
[no] access-control list
<ACL number> ipv4 type-of-
service <0-255>
Defines a Type of Service value for the ACL. For more information on ToS,
see RFC 1340 and 1349.
Command mode: Global configuration
default access-control list
<ACL number> ipv4
Resets the IPv4 parameters for the ACL to their default values.
Command mode: Global configuration
show access-control list
<ACL number> ipv4
Displays the current IPV4 parameters.
Command mode: All