Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 103
Port link configuration
Command: /cfg/port <port number>/gig
[Gigabit Link Menu]
speed - Set link speed
mode - Set full or half duplex mode
fctl - Set flow control
auto - Set auto negotiation
cur - Display current gig link configuration
Use these menu options to set port parameters for the port link.
Link menu options are described in the following table and display on the Gigabit port configuration menus for the
switch. Using these configuration menus, you can set port parameters such as speed, duplex, flow control, and
negotiation mode for the port link.
The following table describes the Gigabit Link Configuration Menu options.
Table 101 Gigabit Link Configuration Menu options
Command
Description
speed 10|100|1000|any
Sets the link speed. Not all options are valid on all ports. The choices include:
10 Mb/s
100 Mb/s
1000 Mb/s
―any,‖ for automatic detection (default)
Note: Ports 1-18 are set to 1000 Mb/s, and cannot be changed.
mode full|half|any
Sets the operating mode. Not all options are valid on all ports. The choices
include:
Full-duplex
Half-duplex
―Any,‖ for automatic detection (default)
Note: Ports 1-16 are set to "Any" and Ports 17-18 are set to full duplex. These
ports cannot be changed.
fctl rx|tx|both|none
Sets the flow control. The choices include:
Receive (rx) flow control
Transmit (tx) flow control
Both receive and transmit flow control (default)
No flow control
auto on|off
Enables or disables auto-negotiation for the port. The default is enabled.
cur
Displays current port parameters.
Port ACL/QoS configuration
Command: /cfg/port <port number>/aclqos
[Port 20 ACL Menu]
add - Add ACL or ACL group to this port
rem - Remove ACL or ACL group from this port
cur - Display current ACLs for this port
The following table describes the port ACL/QoS Configuration Menu options.
Table 102 Port ACL/QoS Configuration Menu options
Command
Description
add acl <1-762>| grp <1-762>
Assigns an ACL or ACL Group to the port.
rem acl <1-762>| grp <1-762>
Removes an ACL or ACL Group from the port.
cur
Displays current port ACL/QoS parameters.