Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 104
Layer 2 configuration
Command: /cfg/l2
[Layer 2 Menu]
8021x - 802.1x Menu
mrst - Multiple Spanning Tree/Rapid Spanning Tree Menu
stp - Spanning Tree Menu
fdb - FDB
trunk - Trunk Group Menu
thash - IP Trunk Hash Menu
lacp - Link Aggregation Control Protocol Menu
vlan - VLAN Menu
upfast - Enable/disable Uplink Fast
update - UplinkFast station update rate
cur - Display current layer 2 parameters
The following table describes the Layer 2 Configuration Menu options.
Table 103 L2 Configuration Menu options
Command
Description
8021x
Displays the 802.1x Configuration Menu.
mrst
Displays the Rapid Spanning Tree/Multiple Spanning Tree Protocol Configuration
Menu.
stp <1-128>
Displays the Spanning Tree Configuration Menu.
fdb
Displays the Forwarding Database Configuration Menu.
trunk <1-12>
Displays the Trunk Group Configuration Menu for the selected trunk (1-12).
thash
Displays the IP Trunk Hash Menu.
lacp
Displays the Link Aggregation Control Protocol Menu.
vlan <1-4095>
Displays the VLAN Configuration Menu.
upfast
enable|disable
Enables or disables Fast Uplink Convergence, which provides rapid Spanning Tree
convergence to an upstream switch during failover.
Note: When enabled, this feature increases bridge priorities to 65500 for all STGs
except STG 128 and path cost by 3000 for all external STP ports.
update <10-200>
Configures the station update rate, in packets per second.
The range is 10-200. The default value is 40.
cur
Displays current Layer 2 parameters.
802.1x configuration
Command: /cfg/l2/8021x
[802.1x Configuration Menu]
global - Global 802.1x configuration menu
port - Port 802.1x configuration menu
ena - Enable 802.1x access control
dis - Disable 802.1x access control
cur - Show 802.1x configuration
This feature allows you to configure the switch as an IEEE 802.1x Authenticator, to provide port-based network
access control. The following table describes the 802.1x Configuration Menu options.
Table 104 802.1x Configuration Menu options
Command
Description
global
Displays the global 802.1x Configuration Menu.
port <port number>
Displays the 802.1x Port Menu.
ena
Globally enables 802.1x.
dis
Globally disables 802.1x. This is the default.
cur
Displays current 802.1x parameters.