Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 114
NOTE: See the N8406-023 1Gb Intelligent L3 Switch Application Guide for information on how to use
port trunks.
The following table describes the Trunk Group Configuration Menu options.
Table 116 Trunk Group Configuration Menu options
Command
Description
add <port number>
Adds a physical port to the current trunk group.
rem <port number>
Removes a physical port from the current trunk group.
ena
Enables the current trunk group.
dis
Turns the current trunk group off.
del
Removes the current trunk group configuration.
cur
Displays current trunk group parameters.
IP Trunk Hash configuration
Command: /cfg/l2/thash
[IP Trunk Hash Menu]
set - IP Trunk Hash Settings Menu
cur - Display current IP trunk hash configuration
The following table describes the IP Trunk Hash Configuration Menu options.
Table 117 IP Trunk Hash Configuration Menu options
Command
Description
set
Displays the Trunk Hash Settings menu.
cur
Display current trunk hash configuration.
Layer 2 IP Trunk Hash configuration
Command: /cfg/l2/thash/set
[set IP Trunk Hash Settings Menu]
smac - Enable/disable smac hash
dmac - Enable/disable dmac hash
sip - Enable/disable sip hash
dip - Enable/disable dip hash
cur - Display current trunk hash setting
Trunk hash parameters are set globally for the switch. You can enable one or two parameters, to configure any of
the following valid combinations:
SMAC (source MAC only)
DMAC (destination MAC only)
SIP (source IP only)
DIP (destination IP only)
SIP + DIP (source IP and destination IP)
SMAC + DMAC (source MAC and destination MAC)
The following table describes the IP Trunk Hash Configuration Menu options.
Table 118 IP Trunk Hash Set Menu options
Command
Description
smac enable|disable
Enable or disable trunk hashing on the source MAC.
dmac enable|disable
Enable or disable trunk hashing on the destination MAC.
sip enable|disable
Enable or disable trunk hashing on the source IP.
dip enable|disable
Enable or disable trunk hashing on the destination IP.
cur
Display current trunk hash configuration.