Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 117
Layer 3 configuration
Command: /cfg/l3
[Layer 3 Menu]
if - Interface Menu
gw - Default Gateway Menu
route - Static Route Menu
arp - ARP Menu
frwd - Forwarding Menu
nwf - Network Filters Menu
rmap - Route Map Menu
rip - Routing Information Protocol Menu
ospf - Open Shortest Path First (OSPF) Menu
igmp - IGMP Menu
dns - Domain Name System Menu
bootp - Bootstrap Protocol Relay Menu
vrrp - Virtual Router Redundancy Protocol Menu
rtrid - Set router ID
cur - Display current IP configuration
The following table describes the Layer 3 Configuration Menu options.
Table 122 L3 Configuration Menu options
Command
Description
if <1-256>
Displays the IP Interface Menu.
gw <1-4>
Displays the IP Default Gateway Menu.
route
Displays the IP Static Route Menu.
arp
Displays the ARP (Address Resolution Protocol) Menu.
frwd
Displays the IP Forwarding Menu.
nwf <1-256>
Displays the Network Filter Configuration Menu.
rmap <1-32>
Displays the Route Map Menu.
rip
Displays the Routing Information Protocol Menu.
ospf
Displays the OSPF Menu.
igmp
Displays the IGMP Menu.
dns
Displays the IP Domain Name System Menu.
bootp
Displays the Bootstrap Protocol Menu.
vrrp
Displays the Virtual Router Redundancy Protocol Menu.
rtrid <IP address>
Configures the Router ID.
cur
Displays the current IP configuration.
IP interface configuration
Command: /cfg/l3/if <1-256>
[IP Interface 1 Menu]
addr - Set IP address
mask - Set subnet mask
vlan - Set VLAN number
relay - Enable/disable BOOTP relay
ena - Enable IP interface
dis - Disable IP interface
del - Delete IP interface
cur - Display current interface configuration
The switch can be configured with up to 256 IP interfaces. Each IP interface represents the switch on an IP subnet
on your network. The IP Interface option is disabled by default. Interface 256 is reserved for switch management.
The following table describes the IP Interface Configuration Menu options.
Table 123 IP Interface Configuration Menu options
Command
Description
addr <IP address>
Configures the IP address of the switch interface, using dotted decimal notation.
For example, 192.2.14.101
mask <IP subnet mask>
Configures the IP subnet address mask for the interface using dotted decimal
notation. For example, 255.255.255.0