Command Reference Guide

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (AOS) 119
IP Static Route configuration
Command: /cfg/l3/route
[IP Static Route Menu]
add - Add static route
rem - Remove static route
cur - Display current static route configuration
The following table describes the IP Static Route Configuration Menu options.
Table 125 IP Static Route Configuration Menu options
Command
Description
add <IP address> <IP
subnet mask> <gateway>
<interface>
Adds a static route. You will be prompted to enter a destination IP address,
destination subnet mask, and gateway address. Enter all addresses using dotted
decimal notation.
rem <IP address> <IP
subnet mask>
Removes a static route. The destination address of the route to remove must be
specified using dotted decimal notation.
cur
Displays the current IP configuration.
Address Resolution Protocol configuration
Command: /cfg/l3/arp
[ARP Menu]
static - Static ARP Menu
rearp - Set re-ARP period in minutes
cur - Display current ARP configuration
Address Resolution Protocol (ARP) is the TCP/IP protocol that resides within the Internet layer. ARP resolves a
physical address from an IP address. ARP queries machines on the local network for their physical addresses. ARP
also maintains IP to physical address pairs in its cache memory. In any IP communication, the ARP cache is
consulted to see if the IP address of the computer or the router is present in the ARP cache. Then the
corresponding physical address is used to send a packet.
The following table describes the ARP Configuration Menu options.
Table 126 ARP Configuration Menu options
Command
Description
static
Displays the Static ARP Menu.
rearp <2-120>
Defines re-ARP period in minutes. You can set this duration between two and 120 minutes.
The default value is 10 minutes.
cur
Displays the current ARP configurations.
Static ARP configuration
Command: /cfg/l3/arp/static
[Static ARP Menu]
add - Add a parmanent ARP entry
del - Delete an ARP entry
clear - Clear static ARP entries
cur - Display current static ARP configuration
The following table describes the Static ARP Menu optionons.
Table 127 Static ARP Configuration Menu options
Command
Description
add <IP address> <MAC address>
<VLAN number> <port number>
Adds a single ARP entry to switch memory.
del <IP address>
Removes a single ARP entry from switch memory.
clear
Clears the entire ARP list from switch memory.
cur
Displays the current ARP configurations.